How To Drill Seep Holes Into The DIY Greywater Aquifer Pipe

How To Drill Holes Into The Greywater Aquifer Pipe In this video we’re going to be showing you how to drill the seep holes. This is the first step when you’re installing the Aquifer Pipes. They are drilled on the both sides of the inner wall with a ¼ drill bit. It’s best to do this on a hard concrete surface this helps prevent the drill bit from going all the way over to the other side. The holes are placed about ¼ inch to 1/8th inch from the bottom. About one foot to ten inches apart. They don’t have to be exact just randomly down both sides of the Aquifer Pipe.

Next thing you want to do is clean it, remove all the debris from the pipe. If there’s any plastic hanging on the holes you especially want to remove that because if any hair, lint or anything gets caught on there it will plug up that hole.

If you do go to the other side we have a video on how to repair the Aquifer Pipe